Mitsubishi electric par-21maa instruction manual simple lecher

Mitsubishi Electric Par-21Maa Instruction Simple Lecher How To Set The

Perform the installation properly according to the installation method.

Please check your inbox, and if you cant find it, check your spam folder to make sure it didnt end up there.

Failure to follow the instructions may result in equipment damage.

These substances can compromise the performance of the unit or cause certain components of the unit to corrode, which can result in electric shock, malfunctions, smoke, or fire.

Dust accumulation and water can cause electric shock, smoke, or fire.

Improperly connected cables may break, overheat, and cause smoke or fire.

Water infiltration and condensation formed inside the unit may damage the circuit board.

Improper installation or repair may cause injury, electric shock, or fire.

The use of this controller for with other systems or for other purposes may cause malfunctions.

To clean the controller, wipe with a soft cloth soaked in mild detergent that is diluted with an appropriate amount of water, and wipe down with a wet cloth followed by a dry cloth.

Air conditioning system may also adversely affect the operation of these types of equipment by creating electrical noise.

Vibrations or shocks to the controller may damage the controller or cause the controller to fall.

Connect to the terminal block at the bottom of the remote controller case.

Connect the remote controller to an arbitrary indoor unit of each refrigerant system you want to group.

Also, when the Main unit is the simultaneous multi type, always satisfy the conditions of (1) above.

When two remote controllers are connected to one group, set the Main remote controller and Sub remote controller.

Mitsubishi Electric Par-21Maa Instruction Simple Lecher How To Set The

For a description of how to set the MainSub setting, refer to the section on initial setting in this manual.).

Only one wire can be connected to the remote controller terminal block.

It can be installed either in the switch box or directly on the wall.

When the room temperature is monitored with the sensor on the remote controller, the built-in sensor on the remote controller monitors the room temperature.

When using the sensor on the remote controller, follow the instructions below.

Removing the remote controller will not be easy with insufficient space.

Mitsubishi Electric Par-21Maa Instruction Manual Simple Lecher